Installation
Refer to FIG.1 for the dimensional requirements.
Remove the fixing screws from the polythene bag, but
leave the appliance in the base tray packaging until you
are ready to install it.
Note:
When removing the appliance from the base tray
packaging care should be taken not to damage the
appliance, follow lifting instructions in the "Before you
start" section.
1. When installing in a typical built in oven housing unit,
the false back should be removed from the housing
unit to provide the necessary depth for installation.
2. When the false back is removed, it is normally the case
that the support shelf for the appliance leaves a gap
between the back edge and the wall of approximately
80mm.
3. If no gap occurs between the back edge of the shelf
and the wall behind the unit, a minimum gap of 30mm
should be created by shortening the shelf, this is to
provide adequate ventilation for the product.
4. Ventilation is required for the product, to allow it to
function correctly, a cutout should cut into the top of
the housing unit (see FIG.1), to provide this.
5. Slide the appliance into position and secure to the cabi-
net using the screws provided.
The appliance is designed to fit into a standard 600mm
wide housing unit, with minimum internal dimensions as
shown in FIG.1 of the installation dimensions.
Please note that all sizes are nominal, and some varia-
tion is to be expected.
28
Warning:
This appliance must be
earthed
!!
!
