Stove Builder International Valcourt FP10 Lafayette, Инструкция по установке и эксплуатации

Страница: 51 / 97

FP10 Lafayette - Installation and Operation Manual
51
7 CLEARANCES TO COMBUSTIBLE MATERIAL
The clearances shown in this section have been determined by test according to procedures set out in
safety standards ULC S610 (Canada) and UL127 (U.S.A.). When the fireplace is installed so that its surfaces
are at or beyond the minimum clearances specified, combustible surfaces will not overheat under normal
and even abnormal operating conditions.
No part of the fireplace may be located closer to combustibles than the minimum clearance figures given.
The following clearances meet the minimum requirements for a safe installation.
Side wall : 24" (61 cm) measured from the inside door frame.
Side mantle : 3" minimum
Wall in front of fireplace : 48"
Ceiling : 80" (2.03 m) measured from the base of the fireplace.
Fireplace enclosure :
Back wall : 0"
Sides : 0"
Floor (under the fireplace) : 0"
Chimney : 2" (50 mm)
Combustible shelf :
58" (147 cm) measured from the base of the fireplace for a shelf with a depth of 6" (15 cm) or less.
64" (163 cm) measured from the base of the fireplace for a shelf with a depth of more than 12" (30
cm).
7.1 Locating the Certification Label
Since the information given on the certification label attached to the appliance always overrides the
information published in any other media (owner’s manual, catalogues, flyers, magazines and/or web site s),
it is important to refer to it to have a safe and compliant installation. In addition, you will find information
about your fireplace (model, serial number, etc.). You can find the certification label under the fireplace,
behind the bottom louver.