Storch PowerCoat, Руководство по эксплуатации

Страница: 112 / 148

112
7. Empty the cup in line with environmental regulations
and repeat the process from 1 - 7 until clean water or sol-
vent is released.
8. Release the trigger safety lock, turn the nozzler to
the cleaning position, and pull the trigger for approx. 5
seconds to ventilate the spray device.
9. After, switch the ventilation/discharge valve down-
wards into the spray position (DOWN). Direct the device
into an empty pail until no more paint is present in the
water or rinsing material.
In order to avoid severe injury or device damage, never
allow electronics to contact the rinsing liquid. When rin-
sing, hold the spray device at least 25 cm above the edge
of the hopper.
The spray area must always be supplied with sufficient
fresh air.
11. Remove the material hopper and dispose of any used
rinsing fluid correctly.
12. Remove the nozzle mount with nozzle and clean this
with the rinsing liquid. To loosen and remove dried-on
materil, use of a soft brush may be necessary.
10. Lock the trigger safety lock and place the ventilation/
discharge valve in the upwards position to discharge the
pressure.
NOTE:
Internal parts must be protected against water. Openings
in the cover provide cooled air to mechanical parts and
electrical components inside the device. If water pene-
trates these openings, this may result in malfunction or
permanent damage to the spray device.