Stone Lift Jockey LJS2000, Руководство по обслуживанию и запасным частям

Страница: 32 / 88

- 32 -
MAINTENANCE
Capacity and Load Center
Know the rated capacity and load center of your
lifter and NEVER EXCEED capacity. The rated
capacity and load center are indicated on the mast
capacity tag located on the Operator’s right hand
side column of the mast. Model numbers on the
mast capacity tag and machine’s serial tag must
match to meet safety standard. The load center for
this machine is 12 inches and is defined as the
longitudinal distance from the heel of the forks to
the center of gravity of the load as illustrated.
CLEANING AND STORAGE
If equipment is taken out of operation for the Winter
season or a prolonged period, follow below proce-
dures to prevent machine or engine damage.
1. Lower mast cylinder and tilt mast forward.
2. Completely clean the outside of the engine.
3. Drain the fuel system and fill it with the
preservative fuel. If preservative fuel is not
used, the system can be kept full with
normal fuel but the fuel must be drained and
discarded at the end of the storage period
together with the fuel filter element(s).
4. Operate the engine until it is warm. Stop the
engine and drain the lubricating oil from the
oil pan.
5. Preservative fluid must be drained and the
lubricating oil pan must be filled to the
correct level with normal lubricating oil at
the end of the storage period.
6. Operate the engine for a short period in
order to circulate the lubricating oil.
7. Disconnect the battery. Then put the battery
into safe storage in a fully charged condi-
tion. Before the battery is put into storage,
protect its terminals against corrosion.
Grease may be used on the terminals.
8. Remove the air filter. Seal the vent pipe of
the fuel tank or the fuel filler cap with
waterproof tape.
Spring Start-Up
1. Drain engine preservative oil and fill with
normal engine oil. Check engine oil level.
2. If fuel preservative was not used, drain and
replace fuel and fuel filter.
3. Charge battery and install.
4. Check air filter.
5. Check hydraulic oil level.
6. Check hardware for looseness. If loose,
tighten according to torque chart.
12 inch = Load Center
12 inch
Capacity & Load/Cleaning &
Storage/Spring Start-Up