STOK SGP2220, Руководство оператора

Страница: 16 / 80

16
ASSEMBLY
Fig. 21
igniToR cAp
AAA bATTERy
(mm)
opd hAndwhEEl
STEP 17: INSTALLING BATTERy IN IGNITOR
See Figure 21.
Remove the following hardware from the blister pack:
MM
- Battery AAA

Turn the ignitor cap counterclockwise and lift cap from
the control panel.

Slide a AAA battery (MM) , negative (—) end first, into the
ignitor. Be sure spring is still in place inside the ignitor cap.
 Replace ignitor cap.
USING LP GAS (LIQUId PROPANE ALSO
cALLEd LIQUId PETROLEUM)
LP gas is highly flammable and may ignite unexpectedly
when mixed with air. The LP gas cylinder used with this grill
must meet the following requirements:
• Constructed and marked in accordance with the
Speci-
fications for LP Gas Cylinders of the U.S. Department
of Transporation (D.O.T.) or the National Standard of
Canada,
CAN/CSA-B339, Cylinders, Spheres, and Tubes
for Transportation of Dangerous Goods; and Commission .
• Measurements: 12 in. diameter x 18 in. tall with 20 lb.
maximum capacity.
• Cylinder valve must have:
— Cylinder connection device (Type
1) compatible with the connector
for the grill
— Safety relief valve
— UL listed Overfill Protection
Device (OPD). This OPD safety
feature is identified by a unique
triangular handwheel. Use only
LP gas cylinders with this type
of valve.
• Arranged for vapor withdrawal and include collar to protect
LP cylinder valve. Always keep LP gas cylinder in upright
position during use, transport, or storage.
wARNING:

Do not store a spare LP-gas cylinder under
or near this appliance:

Never fill the cylinder beyond 80 percent
full;

If the information above is not follwed ex-
actly, a fire causing death or serious injury
may occur.
STEP 18: SEcURING LP GAS cyLINdER ANd
cONNEcTING REGULATOR
See Figures 22 - 25.

Make sure handwheel is in its full OFF position.

With knees bent and in proper lifting position, carefully
lift the LP gas cylinder.

Lower cylinder bottom collar onto middle peg, as shown.

Let cylinder come to rest against cylinder bracket.

Lower cylinder retention bracket down over top collar of
gas cylinder.
NOTE:
Be sure the cylinder is firmly in place.

Remove cap from LP gas cylinder.

Hold the regulator firmly and insert nipple into the gas
cylinder valve.
NOTE: Nipple must be centered in the cylinder valve.
 Holding coupling nut and regulator as shown, turn cou-
pling nut clockwise and tighten by hand taking care not
to crossthread the connection. Do not use tools.
NOTE:
The regulator will seal in the cylinder valve result-
ing in some resistance.
An additional one-half to three-
quarters turn is required to complete the connection.
If you cannot complete the connection, disconnect and
repeat the above two steps. If you still cannot complete
the connection, DO NOT use this regulator!
 Inspect valve connections port and regulator. Look for any
damage or debris. Remove any debris. Inspect hose for
damage. Never attempt to use damaged or plugged
equipment. See your local LP Gas dealer for repairs.