Page 19
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Temperature Adjustment
To display target set point; in programming mode it selects a parameter or confirm an operation.
To start a manual defrost.
To see the maximum stored temperature; in programming mode it browses the parameter codes or
increases the displayed value.
To see the minimum stored temperature; in programming mode it browses the parameter codes or
increases the displayed value.
To switch the instrument OFF, if
onF = oFF
.
Not enabled.
(DEF)
KEY FUNCTIONS:
(UP)
(DOWN)
To lock and unlock the keyboard.
To return to the room temperature display.
KEY COMBINATIONS:
1. Push and immediately release the
SET
key, the display will show the set point value
2. Push and immediately release the
SET
key or wait 5 seconds to display the probe value again
HOW TO SEE THE SET POINT:
1. Push the
SET
key for more than 2 seconds to change the set point value
2. The value of the set point will be displayed and the “°C” LED starts blinking
4. To memorise the new set point value push the
SET
key again or wait 10 seconds
HOW TO CHANGE THE SET POINT:
3. To change the set point value push the or arrows within 10 seconds
To enter in programming mode. (Contact the Stoddart Service Department)
Note:
• The temperature can be set between 65°C and 95°C� How to set the temperature is shown below
• Different modes require different temperatures
• The temperature probe only measures the temperature of the water/air, NOT the food temperature
Operation
Power
• Heat Lamps can be switched ON or OFF with the GANTRY button on the unit
• Lamps MUST be switched ON when the unit is in operation� Steam from operating as a wet unit and/or steam from foods can pool on
the lamps and damage the wiring
Surfaces
• Nothing should be stored on the top of the gantry
• When operating, the surfaces may be hot� Signage should be displayed for personal and customers to ensure no one will burn
themselves
Rear Sliding Doors
• As glass can be HOT, ensure the rear door slide are OPENED and CLOSED with the glass pulls
IMPORTANT
Where a gantry is fi tted over the bain marie, ensure that the
lamps are always on when operating as a wet unit.