Page 9
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Bench Tops (CH.BMC.U)
Under Counter Bench Tops
• Finished opening sizes to bench top should be 5mm smaller than the well opening sizes shown below
• As an example, the finished opening size in the bench for a 3 module Bain Marie will be 1052mm x 543mm
• Ensure sufficient support to provided to the Bain Marie to support the weight of the unit when filled with water
• Well sizes may vary slightly due to the manufacture process� It is recommended that measurements be taken on the actual unit being
fitted
WELL OPENING SIZES TO BAIN MARIE
Module
Width
Depth
3
1057
548mm
4
1397
548mm
5
1737
548mm
6
2077
548mm
7
2417
548mm
8
2757
548mm
Stainless Steel Benchtop
Stone Benchtop
Installation
Cutout Sizes (CH.BMC.D)
Drop-in Bench Top
• Drop-in Counter Line Bain Maries are designed to be installed into a cutout in a new or existing bench top
• Take care to allow for the electrical, water and waste connections (refer to general drawing above)
• Ensure sufficient support to provided to the Bain Marie to support the weight of the unit when filled with water
• Sizes may vary slightly due to the manufacture process� It is recommended that measurements be taken on the actual unit being fitted
BENCH TOP CUTOUT SIZES
Module
Width
Depth
3
1180
805mm
4
1520
805mm
5
1860
805mm
6
2200
805mm
7
2540
805mm
8
2880
805mm