27
26 OPTIONAL Central Beam Assembly
A
Assembly
1
. Attach the two outer beam sections to the centre section (
7
)using the fixing bolt kit (fig
A
) provided ensur-
ing not to trap the electrical supply cables
2
. Attach machines to the outer beam section by using the tipping pin components (fig
B
) and pivot fixing
bolts and spacers (fig
C
) provided. The steel tipping pins then secured in position by the ‘R’ clips (
5
)
NOTE
There are 2 positions for the pin – use these to help level the Fan Jet.
3
. Connect all electrical cables to each Fan Jet unit as required
Ensure there is sufficient room to tip the hopper for emptying and ensure any potential trapping
points are noted taking care not to trap hands or fingers.
The machine must be on level ground or flat surface before tipping the hopper to avoid the hopper
accidently tipping forward once the tipping pin has been removed.
To tip the hopper, remove the pin whilst supporting the hopper, lower gently when emptying the hopper.
NOTE
Adaptor plates shown in fig
D
are not included as part of the standard kit
(for more information contact your local Stock dealer)
C
D
B
A
Ensure care is taken when lifting and securing the central beam to the
parent vehicle and when fitting the machines onto the beam
Safe lifting practice to be observed when handling each component
Parts List
Содержание Fan Jet Duo Plus VS-2 130
Страница 23: ...23 22 Parts drawing...
Страница 30: ...30 29 Notes page...
