2 | User information
STOBER
6
11/2019 | ID 442710.03
2
User information
This documentation aids you in installing and connecting the PN6 communication module in order to connect a SD6 of the
drive controller series (IO device) to a PLC as an IO controller using the PROFINET IO bus system.
Technical knowledge
Operating a PROFINET network requires having familiarity with PROFINET network technology and the basics of the
associated Siemens SIMATIC automation systems.
Technical requirements
Before you begin operating your PROFINET network, you need to wire the drive controllers and initially check that they are
functioning correctly. To do so, follow the instructions in the commissioning instructions for the SD6 drive controller.
2.1
Storage and transfer
As this documentation contains important information for handling the product safely and efficiently, it must be stored in
the immediate vicinity of the product until product disposal and be accessible to qualified personnel at all times.
Also pass on this documentation if the product is transferred or sold to a third party.
2.2
Described product
D
rive controllers of the SD6 series in combination with the DriveControlSuite software (DS6) in V 6.4-D or later and
associated firmware in V 6.4-D or later.
2.3
Timeliness
Check whether this document is the latest version of the documentation. We make the latest document versions for our
products available for download on our website:
http://www.stoeber.de/en/downloads/
2.4
Original language
The original language of this documentation is German; all other language versions are derived from the original language.
2.5
Limitation of liability
This documentation was created taking into account the applicable standards and regulations as well as the current state of
technology.
STOBER shall assume no responsibility for damage resulting from failure to comply with the documentation or from use
that deviates from the intended use of the product. This is especially true for damage caused by individual technical
modifications to the product or projecting and operation of the product by unqualified personnel.
2.6
Formatting conventions
Orientation guides in the form of signal words, symbols and special text markups are used to emphasize specific
information so that you are able identify it in this documentation quickly.
