55
MS 171, MS 181, MS 211
10.5
Rope Rotor
Relieving tension of rewind
spring
– Remove the fan housing and, if
necessary, the segment,
b
10.1
and
b
10.2
Machines with ErgoStart
– Remove the ErgoStart,
b
10.4
All machines
:
Pull out the starter rope (1) about
5 cm and hold the rope rotor (2)
steady.
– While still holding the rope rotor
steady, take three full turns off the
rope rotor.
– Pull out the rope with the starter
grip and slowly release the rope
rotor.
– Remove the starter rope or
remaining rope from the rotor,
b
10.6
The system will not be under
tension if either the starter rope or
rewind spring is broken.
– Remove the spring clip and
pawl(s),
b
10.3
533RA204 TG
1
2
– Remove the washer (1).
Rewind spring must be relaxed.
:
Carefully remove the rope rotor
(2) – the rewind spring may pop
out and uncoil.
– Check the rope rotor and replace
if necessary.
– Coat bore in rope rotor with
STIHL special lubricant,
b
16
– Lubricate starter post with oil,
b
16
:
Fit the rope rotor (2) on the starter
post so that the inner spring loop
(arrow) engages the recess (1).
– Fit the washer.
– Install the pawl(s) and spring clip,
b
10.3
533RA205 TG
1
2
533RA206 TG
2
1
– Install the starter rope,
b
10.6
– Tension the rewind spring,
b
10.7
– Lubricate the peg(s) on the
pawl(s) with grease,
b
16
10.6
Starter Rope / Grip
– Remove the fan housing and, if
necessary, the segment,
b
10.1
and
b
10.2
Machines with ErgoStart
– Remove the ErgoStart,
b
10.4
All machines
– Relieve tension of rewind spring,
b
10.5
The system will not be under
tension if either the starter rope or
rewind spring is broken.
– Remove remaining rope from the
rope rotor and starter grip.
Do not shorten the starter rope.
– Remove the rope rotor,
b
10.5
:
Push the end of the starter rope
(1) out a little and undo the knot.
– Pull the starter rope out of the
rope rotor and fan housing.
533RA207 TG
1
All manuals and user guides at all-guides.com
all-guides.com
