6. MAINTENANCE AND TROUBLE SHOOTING
6. MAINTENANCE AND TROUBLE SHOOTING
33
34
The walking belt of the treadmill has been properly tensioned at the factory.
However, if the walking belt is loose tensioned. please follow this procedure.
One person stands on the walking belt. This person press “START”
button and operates the treadmill for several minutes at 4km/h(2.5mph)
Walk on the treadmill. Tightly grip the handrails and apply force with
feet on the walking belt near the motor cover against the moving belt
direction. If the belt slips, continue to Step 3. If it does not slip, the
tension is correct.
Using the “STOP”button, stop the treadmill. Turn the tension bolts 1/4 turn
clockwise for each side.
Repeat Step 2 and 3 until the belt no longer slips. DO NOT exceed
one full turn per side when adjusting the tension bolts.
Repeat the adjustments until the walking belt appears centered.
Allow the unit to continue running for several minutes to observe if
tracking remains stabilised.
Operate the treadmill at 4km/h(2.5mph), check to make sure proper
tracking.(Refer to "TO CENTER WALKING BELT" on the previous page.)
TO CENTER WALKING BELT (TRACKING)
1. MAINTENANCE TIPS
Safety of the treadmill can be maintained only if the treadmill is examined regularly for
damage or wear. Keep the treadmill out of use until defective parts are repaired or replaced.
After
fi
nishing workout, clean
the contaminated exterior,
display and belt of the
treadmill with a dry cloth.
Inspect and vacuum the
area directly surrounding
and under the unit regularly.
Vacuum around the
walking belt regularly to
keep away debris from
accumulating.
Inspect exterior parts
regularly for wear,particularly
the walking belt, deck and
power cord.
Make sure that the unit is
properly levelled.
!
The procedure in this
manual should be performed
by an authorised service
representative only.
Always unplug the treadmill
from the electrical outlet
before cleaning or servicing
the unit to prevent the
damage caused by electric
shock.
Clean
Clean
Clean
Check the operation of the
STOP key and EMERGEN
CY button once a week.
OFF
ON
!
Forbiddance
Notice
Check
Clean
Clean
WARNING
The walking belt of the treadmill has been properly aligned at the factory.
However, if the walking belt is o
ff
-centered, please follow this procedure.
Turn on the treadmill, press “START”button and set the speed to 4km/h.
If the walking belt has moved to the right, turn the right tension bolt on
the rear roller guard a 1/4 clockwise using 10mm T-wrench and then
turn the left tension bolt 1/4 counter-clockwise to take the walking belt
back to the center of the roller.
If the walking belt has moved to the left, turn the left tension bolt a 1/4
clockwise and then turn the right tension bolt 1/4 counter-clockwise.
Repeat the adjustments until the walking belt appears centered.
Allow the unit to continue running for several minutes to observe if
tracking remains stabilized.
DO NOT exceed one full turn the tension bolts in either direction.
1
2
3
5
6
.
TO ADJUST WALKING BELT TENSION
1
2
3
4
(2.5mph)
Proper environment for human life : temperature 18 C ~ 22 C, Humidity 40~60%
Possible environmental range for installation of STEX equipment :
temperature 10 C ~ 25 C, Humidity 40~70%
Regarding the emergency dismounting : when the user could not catch up the
moving speed you should use the side handrail and the foot platform to dismount.
Safety area of 2000mm(W) x 1000mm(D) behind the equipment.
WARNING
