Final Assembly Cont.
☐
◆
Locate the two holes in the horizontal stab
and mark a center line between them.
☐
◆
Using center line as a guide, bond stab
(use medium CA glue) within slot at trailing
edge of fuselage, aligning perpendicular to
vertical fin and fuselage.
☐
If bellcrank assembly was not installed
previously, cut covering away between ribs
R1 and R2, leading edge sheeting and W8.
Install bellcrank following instructions in Wing
Construction section. Bellcrank and battery
access hole may be left open without
significantly affecting performance of model.
☐
For the best bond , remove a 3/16 in. wide
strip of covering from top center of wing.
Center wing in fuselage. Make sure lead-outs
exit wing on the left side of the aircraft.
Check that wing is square with fuselage and
secure with medium CA.
☐
Bend Tail Skid
- Start with a 4 in. long piece
of .047 in. wire. Make a 90 degree bend 3/8
in. from one end.
Next, make a 45 degree bend one inch from
the first bend as shown.
RingRat 250 © 2010 Stevens AeroModel all rights reserved.
Page 22 of 29