Installing the Monitor
Vividimage
®
4K Surgical Display
OPM3000, Rev. C
Operation Manual
9
3.
Attach the monitor to a boom arm.
Align the display to the mounting holes, and attach the display to the VESA mount attached to the boom arm
using one of the screw sets.
4.
Connect the video and power sources.
a.
Remove the cable cover.
b. Connect the video cable(s) to the appropriate port on the back of the monitor.
Cables are not supplied with the monitor.
c.
Make sure the main power switch is in the off position.
The side of the switch labeled "0" should be pressed down.
d. Attach the power cord to the back of the monitor.
Ensure the video source is turned on. When connecting the monitor to a video source, always turn the
main power switch off, connect the video source, wait about 10 seconds, and then turn the main power
switch on.
e.
Reattach the cable cover with the included screws.
Turn on the monitor.
f.
Turn on the main power switch, and then press the front power button.
g. Orient the monitor in either landscape or portrait mode, if it's attached to a suspension system lets you do
so.
To make sure the monitor doesn't hit the suspension yoke arm, the monitor screen should be fully vertical
or tilted forward toward the floor. Then, with both hands, grip the side bezel of the monitor and rotate the
monitor either clockwise or counter clockwise.
Note:
Orientation may be limited when using a handle and other surgical suspensions or mounts.
Figure 1-1. Close-up of Ports
Figure 1-2. Display Orientation (Landscape to Portrait)
