985-006001 REV. G Effective Date: 03 June 2008
Stereotaxis, Inc.
Page 15 of 43
10
Verify that the C-Arm Collision Detection is operational between the
Niobe
®
and X-ray Systems.
•
Pre-Condition: PM3CTRL not in Service Mode
•
Place the Positioners in the Stowed position.
•
Center Patient Table Laterally
•
Move the C-Arm to RAO 35 degrees:
•
Press the Navigate AP position button on the tableside
controller and verify that the system will NOT move to the
Navigate AP position (starts, but does not complete).
•
Press the Navigate RAO position button on the tableside
controller and verify that the Positioner DOES move to the
Navigate RAO position.
•
Press the Navigate LAO position button on the tableside
controller and verify that the Positioner does NOT move to
the Navigate LAO position (starts, but does not complete).
•
Move the C-arm to the AP position.
•
Press the Navigate LAO position button on the tableside
controller and verify that the Positioner DOES move to the
Navigate LAO position.
•
Press the Manual Retract buttons for the Left then the Right
Pods to the Fully Retracted position.
•
Now simultaneously hold the Image Transfer and any
Navigate button to initiate the interlock override condition
and verify that the system will NOT begin to move to the
Navigate position with the override buttons pressed.
•
Move Table 75mm towards MP2.
•
Press the Manual Advance button to for MP1 to the fully
extended position (max allowable).
•
Press the Manual Advance button for MP2 until the Navigate
Position is achieved.
P F
P F
P F
P F
P F
P F
P F
P F
P F
P F
11
Verify that the system between locations Icon is displayed if the
tableside controller motion button is released prior to the movement
being completed when Pivoting.
•
Verify that you observed the following icon when you release
the motion button prior to the requested position being
achieved.
P F
