INSSTE302P0514
17
trouBleshooting
ProbleM
DeFeCTIVe PArT or PArT To CHeCK
The thermostat is hot.
• In normal operating conditions, the thermostat housing can
reach nearly 40°C at maximum load. That is normal and will
not affect the effective operation of the thermostat.
Heating is always on.
• Check if the thermostat is properly connected. Refer to the
installation section.
Heating does not run even if the
thermostat indicates it is on.
• Check if the thermostat is properly connected. Refer to the
installation section.
The display does not turn on.
• Check if the thermostat is properly connected. Refer to the
installation section.
• Check the power supply at the electrical panel.
• Check if the heating unit has a switch. If so, ensure that this
switch is turned on.
The display turns off a few
minutes and then turns on again.
• The thermal protection of the heating unit has opened due
to overheating. Check if the heating unit is in good condition
of operation and that clearance around the appliance is
according to the manufacturer’s specifications.
The display has low contrast
when heating is on.
• The load is lower than the minimum load. Install a heating
unit that is within the load limits of the thermostat.
The displayed ambient
temperature is incorrect.
• Check the presence of an air stream or a heat source near
the thermostat, and correct the situation.
The display indicates E1, E2,
E3 or E4.
• Faulty thermostat. Contact the customer service.
Weak luminosity of the display.
• Possibility of a bad contact. Check thermostat wirings. Refer
to the installation section.
N.B. If you are unable to solve the problem after having verified these points, please communicate
with our customer service. Consult our website for the phone numbers.
