Assembly Instructions
1. After taking the item out of the box and removing the twist ties, take
the three long pieces that have elements attached to them, and rotate
each element until it snaps into place at a 90° angle to the boom.
2. Set the first boom with nine elements attached, and put the end with
the black cap on the ground.
3. Loosen the wing nuts on brackets on the ends of the brackets.
4. Take the second boom that has no cap on either end, orient it in the
same fashion as the previous boom and insert it into to bracket, and
tighten the wing nut.
5. Take the last boom, orient it so that the black cap is up, and that the
elements are oriented the same way as the previous booms. Insert the
boom into the bracket and tighten the wing nuts.
9. Insert the two reflectors into the bracket at the end of the boom. Both
of the reflectors should overhang the body of the boom. Tighten the
wing nut.
6. Place the boom on the floor with the nubs of the plastic brackets
holding the emitters facing down.
7. Place the drive element assembly through the hole on boom section
with nine elements, towards the end. Tighten the wing nut.
8. Take the bracket with three opening, and place the center opening
onto the end of the boom with nine elements.