Steinberg NUENDO Audiolink 96, Руководство по эксплуатации

Страница: 47 / 136

NUENDO AUDIOLINK 96
English – 47
ENGLISH
We will now create a small submix for the analog
headphone output. Please start a multitrack play-
back and connect your headphones to the analog
output. In playback channel 1 (labeled 'Out 1'), click
onto the routing window below the label. A list
pops up, showing a checkmark in front of '1+2'.
Click onto 'Analog'. The list disappears, the routing
window no longer shows '1+2', but 'Analog'. Now
move the fader with the mouse. As soon as the
fader value is unequal m.a., the present state is be-
ing stored and routing is activated. Move the fader
button to around 0 dB. The present gain value is
displayed below the fader in green letters. In the
lower row, on channels 27 and 28 (AN.L. and AN.R.),
you can also see the level of what you are hearing
in the phones. The level meter of the hardware out-
put shows the outgoing level. Click into the area
above the fader and drag the mouse in order to set
the panorama, in this case the routing between
channels 27 and 28. The present pan value is also
being displayed below the fader.
Please carry out the same steps for 'Out 2' now, in order to route it to
the analog output as well.
Often signals are stereo, i.e. a pair of two channels. It is therefore helpful
to be able to make the routing settings for two channels at once. Press
the [Ctrl]-key and click into the routing window of 'Out 3' with the key
pressed. The routing list pops up with a checkmark at '3+4'. Click onto
'Analog'. Now, channel 4 has already been set to 'Analog' as well.
When you want to set the fader to exactly 0 dB, this can be difficult, de-
pending on the mouse configuration. Move the fader close to the 0 po-
sition and press the [Shift]-key. This activates the fine-mode, which
stretches the mouse movements by a factor of 8. In this mode, a gain
setting accurate to 0.1 dB is no problem at all.
Please set 'Out 4' to a gain of around -20 dB and the pan close to center.
Click onto the routing window. You'll now see two checkmarks, one at
'3+4', the other one at 'Analog'. Click onto 'S/P-DIF'. The window disap-
pears, fader and panpot jump to their initial values and the signal can