SteelMax Rail Runner 2, Руководство оператора

Страница: 23 / 68

Rail Runner 2
Rail Runner 2
– Operator’s Manual
23
Parameter Value Description
Method
of control
Behavior of the arc ignition relay while filling the
crater (only for stitch welding). Rotate
Off. Welding source decreases the current of the arc
while filling the crater. Set the crater fill time higher
or equal to the time of the current lowering that is set
at the welding source.
On. Welding source uses full current while filling the
crater.
Automatic tracking of the welding seam (control
of parameter possible only when the tracking sen-
sor is used). When Z, YZ (require the motorized
vertical slide), or Y is set, you can adjust the initial
torch position from the main screen with F1. Rotate
Off. The welding seam will not be tracked automati-
cally. However, you can adjust the torch position in
the Y axis from the main screen during welding (also
in the Z axis when the motorized vertical slide is
used). Operating mode:
.
Automatic tracking in the Y axis only.
Operating mode:
.
Automatic tracking in the Z axis only.
Operating mode:
.
Automatic tracking in the Y and Z axis.
Operating mode:
.
OR
Sensitivity of the tracking system.
Normal. Press,
hold, and
rotate
Low. The torch adjusts slower to the welding seam.
High. The torch adjusts faster to the welding seam.
cm
inch Unit of measure. Metric or imperial. Rotate
1
–10
Loads the configuration saved under the chosen
program number. No. 1 is factory default. Rotate
Default, Filler,
Linear, Root,
Segment, Top Sample name to describe the loaded configuration. Press,
hold, and
rotate