SteelMax Rail Runner 2, Руководство оператора

Страница: 21 / 68

Rail Runner 2
Rail Runner 2
– Operator’s Manual
21
To set the rest of the parameters, make sure that the direction switch is set to ‘O’.
Next, press and hold the two navigation buttons for three seconds to show the first
setup screen (Fig. 12).
Fig. 12. First setup screen
To go to the next setup screen, press the right navigation button. To go to the
previous setup screen, press the left navigation button.
Use the knobs to set the required values of parameters (Tab. 3).
Tab. 3. Parameters shown on the setup screens
Parameter Value Description
Method
of control
Weld path. Rotate
Triangle. The carriage travels only during oscillation.
During oscillation dwell time, the carriage stops to fill
the crater.
Trapezoid. The carriage travels at all times, also
during oscillation dwell time.
Square. The carriage travels only during oscilla-
tion dwell time in left and right position. During oscil-
lation, the carriage stops. During oscillation dwell
time in center position the carriage fills the crater.
Behavior when the limit switch is activated. Rotate
Stops the carriage and arc. To continue, set the
direction switch to ‘O’. This travels the carriage back
by 10 mm (0.5 in) and removes the information
symbol.
Stops the arc and travels the carriage back to the
initial position from where the move started.
To continue after the carriage reaches the initial
position, set the direction switch to ‘O’. This removes
the information symbol.