Page 15 of 38
939564909 Rev B
®
Attach driveshaft covers using four (4) screws
1
Attach Driveshaft Covers and
To maximize available space on the back of the
2
each, into the pre-drilled pilot holes.
Wire Managers
worksurface for clamping accessories, place the
wire manager over the driveshaft cover as shown.
Attach with either two (2) or three (3) screws.
WIRE MANAGER IS
PUSHED UP AGAINST
DRIVESHAFT COVER.
BACK OF
WORKSURFACE
1b
ALIGN HOLES IN COVER
WITH PILOT HOLES IN
WORKSURFACE.
TWO SCREWS
PER SIDE
NOTE:
There should be about
1/4" between the motors and
the driveshaft covers.
~
1/4"
MOTOR
DRIVESHAFT
COVER
ROUTE SWITCH CABLE
THROUGH THIS AREA
NOTE:
The cover is eliminated
on assemblies with a
Power & Data Tray.
2
WIRE MANAGER
WIRE MANAGER
Series 5 Table Assembly (cont.)
NOTE:
Assemblies with a Nexsis Power Access
Door Package do not use a driveshaft cover.
NOTE:
Assemblies with a Nexsis
Power Access Door Package require
the Wire Manager to be installed at
an alternate location as shown.
1a
COVER
#2 SQUARE DRIVE
WORKSURFACE SCREW
