Instructions
Assembly Installation Operation
Page 1 of 2
10/2014
Carousel Table with Four Seats
Table Components:
(2) table/seat supports
(1) table top
(4) seats
Note: Marneaux tabletop ships with a circular adapter plate installed, do not remove.
Hardware:
(18) 1/4" x 3/4" Phillips tapping screws for Steelhead and Catena table top OR
(4) 1/4-20 x 3/4” Phillips machine screws with washers for Marneaux table tops
(6) 3/8-16 x 1” hex head machine screws with washers for seats
(1) 1/4-20 x 2-1/4 Phillips machine screw and lock nut for umbrella (sold separately)
(Glides for freestanding support and anchor tabs for surface mount support are factory installed.)
Tools Required:
#3 Phillips screwdriver for Steelhead, Catena, and Marneaux table tops
9/16" socket and ratchet for seat screws
HANDLE WITH CARE!
Pangard II
polyester powder coat is a strong, long-lasting finish. Protect this finish from damage during
assembly. Place unwrapped powder coated parts on packaging foam or other non-abrasive surface. Do not place or slide
powder coated parts on concrete or other hard or abrasive surfaces – this will damage the finish causing corrosion to occur. Use
touch-up paint to repair any finish abrasions.
Assembly:
1. Lay table top upside down on a non-marring surface.
2. Place support A (has 5" ring at center) upside down on table top. Insert screws loosely (6 for Steelhead and Catena or 2 at
ends of plates for Marneaux).
SUPPORT "A”
3. Hold support B upside down and carefully lower it over support A. Place bar of support B into notch in ring on support A.
Insert screws loosely as before.
SUPPORT "B"
Carousel Table with Four Seats continued
4. Tighten all table top fasteners until snug, then tighten additional 1/4 turn.
[The use of power drivers is not
recommended with Marneaux tabletops. Threaded inserts may be damaged or broken due to over-torquing.]
5. Turn table right side up, using at least 2 people.
