Page 22 of 38
939564909 Rev B
®
Series 8 Table Assembly (cont.)
Attaching the Controller
4
NOTE:
Push button stick-on controller installation is
shown here. However, the controller cannot be installed
until the worksurface is flipped over.
NOTE:
Remove paper backing from controller
before installation.
Install the Controller to the underside of the worksurface
on the side preferred by the user, using the pre-drilled
pilot holes. Plug the RJ-45 end into either port on the
Control Box.
Push Button Stick-On Controller
Digital Desk
Panel Controller
Standard
Controller
5
Install the cable clips for the control wire. Peel off paper
backing and stick to worksurface. Place wire into each
cable clip.
CONTROL
WIRE
PAPER BACKING
CABLE CLIP
4
5
#2 SQUARE
DRIVE
#8 x 5/8 SCREW
(SILVER)
