Page 9 of 18
939564905 Rev E
®
Attaching Control Box & Controller (continued)
Install the controller to the underside
of the worksurface on the side
preferred by the user, using the
pre-drilled holes. Plug the RJ-45
end into controller port
A1
on
the control box.
11.
Install the cable clips for the control wire.
Peel off paper backing and stick to
worksurface. Place wire into each cable
clip.
12.
NOTE:
Push button stick-on controller
installation is shown here. However, the
controller cannot be installed until the
worksurface is flipped over. Once step 18
is performed, the controller may then be
installed.
NOTE:
Remove paper backing from
controller before installation.
Digital Desk
Panel Controller
Standard
CABLE CLIP
PAPER BACKING
Controller
Push Button Stick-On
Controller
8-15 X 0.625”
SCREW
11
12
NOTE:
If the table is plugged into a power source before the Digital Desk Panel
Controller is plugged into the control box, the table will not move.
If this does occur, disconnect the table from the power source. Then, plug the controller
into port A1 of the control box. Wait at least 20 minutes before connecting the table
back into the power source.
