Page 16 of 20
18719901 Rev G
®
Synchronizing the Lifting Columns
Prior to initial use of the height adjustment
function you must "synchronize the system".
•Press the Down arrow until the worksurface
comes to a stop at the lowest position.
•Release the Down arrow.
•Press and hold the down arrow for approximately
5 seconds while the table synchronizes itself. The
surface will quickly lower itself approximately 5mm
then rise approximately 5mm and finally settle
back to its lowest position.
After performing this function, the movement of all
lifting columns is synchronized by software inside
the control box.
In the unlikely event that an error occurs, reset the
control unit by pressing the Up and Down buttons
at the same time for 5 seconds. Then repeat the
synchronizing sequence as previously outlined
above.
GLIDE
NOTE:
Mounting of CPU and
CPU holders: Maximum height
for the 2 units cannot exceed
20-1/2".
Before use, the table must be completely leveled,
front-to-back and side-to-side using the height
adjustable glides. Failure to do this
could cause the lifting
columns to bind.
Before articulation, you
must synchronize the
lifting columns as
outlined below.
Digital Desk
Panel Controller
Standard
Controller
Push Button Stick-On
Controller
19
20
Finishing the Table Assembly (cont.)
