Page 12 of 19
OPERATIONS
STEP 4: Add the Gum Removal Solution
Empty the concentrated gum removal solution into the fluid
reservoir.
Fill the remainder of the fluid reservoir with clean cold
water.
To maintain the correct ratio of water to solution, do not
refill the fluid reservoir or add solution until the Fluid LED
indicates that the fluid reservoir is less than 10% full.
STEP 5: Start the machine
Turn the dial on the top of the machine to ‘R’ (rinse).
Turn on the power switches:
-
on the machine
-
on the lance / wand
Wait for liquid to be seen flowing from the nozzle for at least
10 seconds.
Turn the flow dial to
•
and wait until steam is seen emitting
from the nozzle.
Note
: If all three LED’s flash at this stage highlighting an
error, turn off both power switches and repeat Step 5.
STEP 6: Remove the gum
Select the correct flow dial setting:
•
For
normal
fluid level in the steam (eg hard surfaces)
••
For
increased
fluid in the steam (eg carpet and
tarmac)
Note: If you are cleaning a carpet or other material surface,
we recommend testing a small area before using this
solution to ensure you are satisfied with the result.
Place the brush on the piece of flattened gum and wait for
5
– 10 seconds.
