Stealth Cam STC-G42C, Инструкция по эксплуатации

Страница: 13 / 54

www.stealthcam.com Page
877-­‐269-­‐8490
13
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
o
TIME LAPSE (TL): In this mode the camera will take a designated amount of pictures with a
designated time out between the designated hours of operation even if there is no activity in
front of the camera.
§
PHOTO RES – 5.0 MP (default): This setting is used to determine the Megapixel resolution of each
image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 8MP, 5MP, 2MP or .5MP. The higher the resolution of an image the more
space the file will take on the SD memory card.
§
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN
arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 05 to 59
(05 to 59 if minutes = 00).
•
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE
images. This setting can be changed between the numbers of 00min 05sec to 59min 59sec. With
this option blinking, use of the UP and DOWN arrows will allow the minutes setting to be changed
from 00 to 59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move
to the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00). If the TL Delay is greater
than or equal to 1 min, then the PIR sensor will be active between time-­‐lapse photos.
•
TL START – 06:00PM (default): This setting is used to give the camera the start time for when to
start the time-­‐lapse photography. The default format is in a HH/MM/AP setup, should the time
format be in 24 hour the format it will show HH/MM. With the HH (hour) setting blinking, use the
UP and DOWN arrows to allow the setting to be changed from 1 to 12. Once this setting is on the
appropriate hour, press the RIGHT arrow key to move to the MM (minute) setting and it will start to
blink.