Starmix Airstar H-C1 M, Руководство по эксплуатации

Страница: 21 / 40

21
en
Connecting the device to the power supply
See Fig. H, I, J, K
Observe the following conditions for the electrical connection:
– Only connect the device to a properly installed grounded socket.
– With fixed connection: Supply line must have a switch-off device, e.g. a circuit breaker that can be
switched off or a screw-in fuse.
– Connect the device to an electrical supply line with a residual current circuit breaker.
– Do not connect other loads to the electrical supply line of the device.
DANGER
Live electrical supply line and device components!
Risk of deadly electric shock in case of contact.
Before performing any work on the device:
1. Unplug power cord. With fixed connection: Switch off circuit breaker or unscrew fuse.
2. Secure against accidental switching on.
Guiding the electrical cables through the rear wall of the hair dryer housing (see Fig. H):
1. Guide the spiral cable through the opening in the rear wall of the housing.
2. Guide the protective earth wire through the opening in the rear wall of the housing.
Collecting the protective earth connections in the housing of the hair dryer (see Fig. I):
1. Establish protective earth connection between screw terminal and plug-in terminal (Fig. A, item 11). Use
70 mm protective earth wire for this (Fig. A, Item 9).
2. Plug the protective earth wire of the guide carriage into the plug-in terminal.
3. Plug the protective earth wire of the hair dryer hood into the plug-in terminal.
Connecting the spiral cable to the hair dryer (see Fig. I):
1. Connect the spiral cable to the screw terminal.
2. Insert the spiral cable together with protective earth wire of the guide carriage into the strain relief and fix
in place.
Placing the hood on the hair dryer (see Fig. J):
1. Place hood on the hair dryer. NOTICE! Do not damage the protective earth wire. Ensure that the motor
protection filter is correctly seated.
2. Tighten the lower two fastening screws of the hood.
3. Tighten the upper two fastening screws of the hood.
Connecting the electrical supply cable to the height adjustment (see Fig. K):
1. Depending on the desired cable routing: Break out the opening on the top of the cover cap or on the back
of the profile cover.
2. Insert the grommet into the broken out opening.
3. Pass the supply cable through the grommet.
4. Connect the electrical supply cable to the screw terminal.
5. Insert the electrical supply cable into the strain relief (Fig. A, Item 16) and fix it with screws (Fig. A, Item 7).
6. Fit the cover.
7. Plug the plug into the socket, switch on the automatic fuse or screw in the fuse.