– 37 –
10-2. Auto Cutter Specifications
(1) Cutting frequency
Max. 20 cuts per minute
(2) Thickness of paper
0.065 ~ 0.15 mm
10-3. Interface
RS-232C serial interface/Two-way parallel interface (IEEE1284)/USB interface/Ethernet in-
terface/Wireless LAN Interface
10-4. Electrical Characteristics
(1) Input Voltage
DC 24 V±5%
(2) Current Consumption (DC 24 V at room temperature)
Standby:
Approx. 0.15 A
ASCII printing:
Approx. average 1.8 A
(Approx. 17.5% printing rate)
100% print duty:
Approx. peak 11.9 A
(Solid printing):
Approx. average 5.0 A
(Continuous solid printing should be 10 seconds or less.)
(3) Power Connector
Pin No.
Function
1
Drive power (24 V)
2
Signal GND
3
N.C.
Shell
Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-24 series),
be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±5% and more than 2.0 A (5.0 A Load 10 sec. Min)
with LPS output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
<Viewed from Connector Surface>
