– 18 –
4-1. Attaching the Holder Plate
(1) Attach the shaft to the printer.
(2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then,
affix the roll stoppers. The positions for affixing them will vary depending on the paper
width.
(3) Use a regular screwdriver to remove the clips at both
ends of the bar to remove the tension bar unit.
Note:
If the paper witdth is 79.5 or 82.5mm and the
paper thickness is less than 100μm, you do not
need to remove the tension bar unit.
Shaft
82.5 or 79.5 mm width
57.5 mm width
Push in the left and
right ends of the shaft.
