– 14 –
3-7-2. Changing the Adjustment Lever Position
The adjustment lever position must be changed in accordance with the paper thickness. It is
factory-set to position
1
. When using paper thickness between 100 and 150 μm, change the
adjustment lever position in accordance with the procedure below.
As shown, use a flat head screwdriver to move the adjust-
ment lever inward. Then, lower the adjustment lever to
the position in which the protrusion on the adjustment
lever engages with the hole in the frame.
Note:
Do not use position
2
.
Position
3
Paper thickness
between 105 μm and 150 μm
Position
1
Paper thickness
between 65 μm and 105 μm
3-7-3. Removing the Paper Roll Holder
When using a paper roll with an 82.5 mm width, remove the paper roll holder as shown.
When using a paper roll with a 57.5 mm width, remove the paper roll holder, and install the
paper roll holder into the other groove. In either case, change the setting at memory switch #4.
For instructions on setting the memory switch, refer to the separate Specifications Manual.
Note:
After using a paper roll with a width of 57.5 mm, do not change to a paper roll with
a width of 79.5 or 82.5 mm. This is because the printer head has deteriorated as a
result of a portion of the head having been in direct contact with the platen.
Paper roll holder
