Star Headlight & Lantern STARSIGNAL LCS771, Инструкция по установке и эксплуатации

Страница: 5 / 16

-3-
Terminal
Description
Typical
Color
Typical
Current
1 Power Red 10A* 20A
Total
2 Power Red 10A*
3 Ground Black 10A*
4 Ground Black 10A*
5 Speaker 1 Brown 4A
6 Speaker 2 Brown 4A
7 AUX In Green 3A
8 AUX Out Orange 3A
9 Radio Repeat Blue 0.1A
10 Radio Repeat Blue 0.1A
11 Backlighting Yellow 0.1A
12 Park/Kill Input White 0.1A
20A
Total
CPSS-153 WIRING GUIDE
Current 10' 20' 25'
< 2.0A 22 AWG 18 AWG 18 AWG
2.0-4.0A 18 AWG 16 AWG 16 AWG
4.1-5.5A 18 AWG 16 AWG 14 AWG
5.6-8.0A 16 AWG 14 AWG 14 AWG
8.1-12.0A 16 AWG 12 AWG 12 AWG
RECOMMENDED WIRE GAUGE
* 5A for LCS771-28
Wire Size and Termination
Examine the charts below to determine the proper gauge of the wire to use. Please
review the following recommendations when making your electrical connections:

For safety and reliability we highly recommend that you always use both Ground
terminals (3 & 4 on the green connector) and all of the Power terminals (1 & 2 on
the green connector, the three outer metal terminals, and the two red wires
found in each wire bundle).

Use only high quality crimp connectors. Make sure all connections are tight.

Minimize the number of splices to reduce voltage drop.

Route wiring to prevent wear, overheating, and interference with air bag
deployment.

Use grommets and sealant when passing through compartment walls.

Ground connections should be made directly to the negative of the vehicle
battery . Where not possible, only connect to substantial chassis components.

Install and check all wiring before connection to vehicle battery.

CAUTION: All wires should be rated for at least 125% of their maximum current
load. All wires connected to the positive terminal of the battery should be fused
at the battery for their rated load.

Review the charts below that indicate the recommended wire gauge, based
upon the length of the wire run and the current that will pass through the wire.
(Electrical Connections CONT’D)
For ease of installation, you can
remove the green connector from
the siren while connecting your
wires. Please note that when
referencing terminal numbers
using the wiring diagram on page
2, the screw heads face
UP , as
pictured to the right.
Connections to the terminal block are summarized both in the chart above and in
the wiring diagram on the previous page. For more detailed information, review the
section on the following page.