Stanley STSC1618, Руководство пользователя

Страница: 8 / 44

Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
Labels on tool
The label on your tool may include the following symbols
along with the date code:
8
ENGLISH
(Original instructions)
• Support large panels. Large panels must be supported
as shown (Fig. A) in this manual to minimize the risk of
blade pinching and kickback. Material supported only at
the ends (Fig. B) will lead to blade pinching. When
cutting operation requires the resting of the saw on the
workpiece, the saw shall be rested on the larger portion
and the smaller piece cut off.
• Use only correct blades and blade assembly
components when mounting blades. Do not use
blades with incorrect size holes. Never use defective or
incorrect blade washers or bolts. Follow blade assembly
procedures.
Saw blades
• Do not use blades of larger or smaller diameter than
recommended. For the proper blade rating refer to the
technical data. Use only the blades specified in this
manual, complying with EN 847-1.
Warning! Never use abrasive wheels.
Safety of others
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do
not play with the appliance.
Position of date barcode
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing
Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
STANLEY Service Center or an equally qualified person in
order to avoid damage or injury. If the power cord is replaced
by an equally qualified person, but not authorized by
STANLEY, the warranty will not be valid.
• Adjustments. Before cutting be sure depth and bevel
adjustments are tight.
• Support and secure the work properly. Insure that the
material to be cut is clamped (Fig. C), and solidly