Stanley STGS1125, Руководство пользователя

Страница: 8 / 52

8
ENGLISH
(Original instructions)
Caution! Allow the tool to reach full speed before
touching tool to the work surface. Lift the tool from
the work surface before turning the tool off.
Spindle lock
The spindle lock button (5) is provided to prevent the spindle
from rotating when installing or removing wheels. Operate
the spindle lock only when the tool is turned off and the
wheel has come to a complete stop.
Warning! Do not engage the spindle lock while the tool is
operating. Damage to the tool will result and attached
accessory may spin off possibly resulting in injury.
To engage the lock, depress the spindle lock button shown
in Fig. E and rotate the spindle until you are unable to rotate
the spindle further.
Mounting And Using Depressed Center
Grinding Wheels And Sanding Flap Discs
Mounting and Removing Hubbed Wheels
Warning! To prevent accidental operation, turn
off and unplug tool before performing the
following operations. Failure to do this could
result in serious personal injury.
Hubbed wheels install directly on the 5/8 in.-11 threaded
spindle.
1. Thread the wheel on the spindle by hand.
2. Depress the spindle lock button and use a wrench
(Fig. E) to tighten the hub of the wheel.
3. Reverse the above procedure to remove the wheel.
Caution! Failure to properly seat the wheel before
turning the tool on may result in damage to the tool
or the wheel.
Mounting Non-Hubbed wheels
Warning! To prevent accidental operation, turn off
and unplug tool before performing the following
operations. Failure to do this could result in serious
personal injury.
1. Figure F : Install the unthreaded backing flange (10) on
spindle (11) with the raised section (pilot) against the
wheel.
2. Place wheel against the backing flange, centering the
wheel on the raised section (pilot) of the backing flange.
3. Figure G: While depressing the spindle lock button,
thread the threaded clamp nut (12) on spindle.
► Figure H: If the wheel you are installing is more than 1/8
inch (3mm) thick, place the threaded clamp nut on the
spindle so that the raised section (pilot) fits into the
center of the wheel.
► Figure I: If the wheel you are installing is 1/8 inch (3mm)
thick or less, place the threaded clamp nut on the spindle
so that the raised section (pilot) is not against the wheel.
4. While depressing the spindle lock button (5), tighten the
threaded clamp nut with included wrench.
5. To remove the wheel, depress the spindle lock button
and loosen the threaded clamp nut with included wrench.
Note: If the wheel spins after the threaded clamp nut is
tightened, check the orientation of the threaded clamp nut. If
a thin wheel is installed with the pilot on the clamp nut
against the wheel, it will spin because the height of the
pilotprevents the clamp nut from holding the wheel.
Surface grinding with grinding wheels
1. Allow the tool to reach full speed before touching the tool
to the work surface.
2. Apply minimum pressure to the work surface, allowing
the tool to operate at high speed. Grinding rate is
greatest when the tool operates at high speed.
3. Figure J: Maintain a 20˚ to 30˚ angle between the tool
and work surface.
4. Continuously move the tool in a forward and back motion
to avoid creating gouges in the work surface.
5. Remove the tool from work surface before turning tool
off. Allow the tool to stop rotating before laying it down.
Maintenance
Cleaning
Warning! Blowing dust and grit out of the motor
housing using compressed air is a necessary
maintenance procedure. Dust and grit from metal
grinding often accumulate on interior surfaces and could
create an electrical shock hazard if not cleaned out.