Stanley SGS1115, Инструкция по эксплуатации

Страница: 23 / 26

23
ENGLISH (
Original Instructions)
SPECIFIC SAFETY WARNINGS
FOR POLISHING OPERATIONS
♦ Do not allow any portion of the polishing bonnet to get
loose or prevent its cords from rotating freely. Save
or cut any loose cords. Loose cords can become
entangled with your fingers or stuck in the workpiece.
SPECIFIC SAFETY WARNINGS
FOR METAL BRUSHING
♦ Note that some of the wire bristles on the brush
become loose and fall even during normal
operation. Do not force the wires by applying
excessive pressure on the brush. The wire bristles
can easily penetrate light clothing and/or skin.
♦ If the use of a guard for metal brushing is
recommended, do not allow any interference from
the wheel or from the wire brush with the guard.
The wire brush or wheel may expand in diameter due
to workload or centrifugal force.
PERSONAL SAFETY
♦ No children or pregnant women should enter the work
rea where the paint sanding is being done until all
cleanup is completed.
♦ A dust mask or respirator should be worn by all persons
entering the work area. The filter should be replaced
daily or whenever the wearer has difficulty breathing.
Note: only those dust masks suitable for working with lead
paint dust and fumes should be used. Ordinary painting
masks do not offer this protection. See your local hardware
dealer for the NIOSH approved proper mask.
ENVIRONMENTAL SAFETY
♦ Paint should be removed in such a manner as to
minimize the amount of dust generated.
♦ Areas where paint removal is occurring should be
sealed with plastic sheeting of 4 mils thickness.
♦ Sanding should be done in a manner to reduce tracking
of paint dust outside the work area.
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear ear protection.
Wear safety glasses or goggles.
V Volts Direct Current
A Amperes n
0
No-Load Speed
Hz Hertz Class II Construction
W Watts Earthing Terminal
min minutes Safety Alert Symbol
Alternating
Current
/min.
Revolutions or
Reciprocation per
minute
Position of Date Code (Fig. A)
The Date Code (10), which also includes the year of
manufacture, is printed into the housing.
Example:
2016 XX JN
Year of manufacturing
PACKAGE CONTENTS
The package contains:
1 Angle Grinder
1 Side Handle
1 Wrench
1 Grinding Wheel
1 Instruction Manual
♦ Check for damage to the tool, parts or accessories
which may have occurred during transport.
♦ Take the time to thoroughly read and understand this
manual prior to operation.
ELECTRICAL SAFETY
Your tool is double insulated; therefore no earth wire
is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be
replaced by the manufacturer, authorized Stanley
Service Center or an equally qualified person in order
to avoid damage or injury. If the power cord is replaced
by an equally qualified person, but not authorized by
Stanley, the warranty will not be valid.
USING AN EXTENSION CABLE
If it is necessary to use an extension cable, please used
an approved extension cable that fits the tool’s power input
specifications. The minimum cross-sectional area of the
conducting wire is 1.5 sq. mm. Cables should be untangled
before reeling up.
Cable cross-sectional
area (mm
2
) Cable rated
current (Ampere)
Cable cross-sectional
area (mm
2
) Cable rated
current (Ampere)
0,75 6
1,00 10
1,50 15
2,50 20
4,00 25
Cable length (m)
7,5 15 25 30 45 60