Stanley SCT12, Руководство пользователя

Страница: 9 / 56

9
ENGLISH
d. Release button
e. Charger
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
DO NOT let children come into contact with the tool. Supervision
is required when inexperienced operators use this tool.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities, or for lack of experience and/or for want of
knowledge or skills unless they are supervised by a person
responsible for their safety. Children should never be left
alone to play with this product.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your STANLEY charger is double insulated in
accordance with EN 60335; therefore no earth wire
is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY service
organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data ). The
minimum conductor size is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Assembly and adjustments
WARNING: Prior to assembly and adjustment,
always remove the battery pack. Always switch
off the tool before inserting or removing the
battery pack.
WARNING: Use only STANLEY battery packs
and chargers.
Inserting and Removing the
Battery Pack from the Tool (Fig. 3)
WARNING: To reduce the risk of serious
personal injury, place the forward/reverse
button in the lock-off position or turn tool off
and disconnect battery pack before making
any adjustments or removing/installing
attachments or accessories. An accidental
start-up can cause injury.
NOTE: Make sure your battery pack (c) is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL
HANDLE
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into
place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (d) and firmly pull the battery pack
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Operation
INSTRUCTIONS FOR USE
WARNING: Always observe the safety
instructions and applicable regulations.
SWITCH (Fig. 2)
To turn the light on, press the switch (a). To turn it off, press the
switch again.
PIVOTING HEAD (FIG. 1, 3)
The pivoting head (b) provides light in any direction by rotating
90˚ in one direction.
Maintenance
Your STANLEY power tool has been designed to operate over a
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
• Do not attempt to repair the worklight. To assure
product safety and reliability, repairs, maintenance, and
adjustments should be performed by authorized STANLEY
service centers.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust mask
when performing this procedure.