Rev: Dec2010
12 of 18
®
STANLEY Electric Pressure Washers
OPERATION
Step 7
Adjusting the spray
Turning the nozzle allows the use of several different spray.
CAUTION:
Jet spray adjustment is very aggressive. Do not adjust while
spraying. We recommend that for most cleaning applications, a 20
degree spray angle should be used to avoid damage to the surface
being sprayed.
Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for 3-5 minutes without
pressing the trigger on the spray gun, circulating water in the pump can
reach temperatures above 125°F.The system engages to cool the pump
by
discharging the warm water onto the ground.
Select the desired high pressure spray angle by using the high pressure adjustable wand.
To scour surfaces, adjust wand to D or E angle.
For gentle rinse, adjust wand to B or C angle.
To apply chemical, adjust to low pressure as shown in angle A (for instructions on
adjusting the wand to low pressure, see step 1 on page 13.
High pressure spray could cause you to fall if you are too close to the
cleaning surface.
Keep spray nozzle between 8 to 24 inches away from cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure washer from a ladder,
scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high pressure spray to
avoid injury if gun kicks back.
WARNING
A B C D E
You must attach all hoses before you start the engine.
Starting the engine without all the hoses connected and without the water
turned ON will damage the pump.
Damage to equipment resulting from failure to follow this instruction will
void warranty.
CAUTION
