11 of 18
®
STANLEY Electric Pressure Washers
Rev: Dec2010
OPERATION
Step 1:
Make sure that the ON/OFF switch is in the “OFF” position.
Step 2:
Turn ON the water supply.
CAUTION:
Jet spray adjustment is very aggressive. Do not adjust while
spraying. We recommend that for most cleaning applications, a 20
degree spray angle should be used to avoid damage to the surface
being sprayed.
Step 3
Push the primer bulb 3 to 5 times before starting a cold engine.
Step 4
Before turning the unit “ON”, depress the trigger to bleed any
trapped air out of the pump and hose.
Step 5
Release trigger and start the pressure washer by turning ON/OFF
switch to ON.
Important:
Never turn the engine on without having the water turned on.
Running the pump with no water can cause pre-mature pump
damage.
Step 6
Pull the recoil to start. To start easier, hold the trigger on the gun
to allow the water to flow. If engine does not start after the 4 or
5th pull, contact customer service at 919-550-3259 for assistance.