8
4. Operation Guide (Operating Steps Instructions)
When power is turned on, the controller starts self testing automatically, the LCD Display indicating the self
testing progress. After it is finished, the fixture pilot on the rear board is on, which means that you can start to
operate the controller.
4.1 Programming Mode
Press PROGRAM button for 3 seconds, the LED above this button lights blinking
indicating Program in active.
4.2 Setting a scene
1. Enter Program mode.
2. Press the button 1-20 to select Fixture, you can select several fixtures at a time by
tapping of these buttons.
3. Slide Faders 1-24 or use the CENTRE or PRESET or SCENE have saved to change
the output of each channel. You can also use the jog wheel #1 & #2 to control the
PAN, PAN FINE or use the jog wheel #3 #4 to control TILT, TILT FINE.
4. Once the scene is satisfactory, press MANUAL/REC button to program this scene
into memory. At this moment, the LEDs on CUE, OVERRIDE, CENTRE, FIXTURE
GROUP, PRESET, CHASE, BANK, BLACKOUT button blink at the same time.
5. Press BANK use the Jog wheel #1 to select the BANK number to save the scene.
6. Press the number button 1-20 to select the Scene number going to be saved, all
LEDs and the Segment Display will blink three times briefly indicating this operation,
then the LCD will show the bank and the scene number of the programmed scene.