Stahl EC-910-AFZ, Инструкция по эксплуатации

Страница: 21 / 214

Instruc
tion manual - English - EN
19 MNTCMMX_2040_EN
6.6 Connection of the power
supply line
6.6.1 Connection of the power supply
line, 24Vac/24Vdc (version of the
product not cabled)
Check that the power supply socket and
cable are adequately dimensioned.
The polarity of the voltage, applied to the
power terminal, is irrelevant.
CONNECTION OF THE POWER SUPPLY LINE
Power supply 24Vac/24Vdc
Colour
Terminals Cable section
Defined by the installer ~/+ from 0.14mm² (28AWG)
up to 1.5mm² (16AWG)
Defined by the installer ~/- from 0.14mm² (28AWG)
up to 1.5mm² (16AWG)
Tab. 6
CABLES SPECIFICATIONS
Cable section Supply voltage Maximum cable
length
1.5mm² (16AWG) 24Vdc 20m (66ft)
24Vac 40m (131ft)
Tab. 7
The power supply cable must be covered
by the silicone sheath (01) supplied. The
silicone sheath must be fastened with the
corresponding cable tie (02).
Fig. 21
The power supply cables should be connected to the
power supply terminal of the housing board (J1, 6.5
Housing board description, page 18).
6.6.2 Connection of the power supply
line, PoE+ (version of the product not
cabled)
The product can be powered using PoE+ (Power
Over Ethernet) devices in compliance with the
international standard for technological information
IEEE 802.3at, using an Ethernet data cable Category
5E.
02
01
N/-
L/+
Maximum Ethernet cable length (category
5E): 100m.
The PSE (Power-Supplying Equipment) devices
suitable for the product power supply must comply
with the standard IEEE 802.3at (PoE+).
The Ethernet cable should be connected to
connector RJ45 of the housing board (J8, 6.5 Housing
board description, page 18).
The Ethernet cable shield must always be
earthed via the connector. Always use a
shielded RJ45 connector.
Carry out the connections as described in the table
(according to the standard: TIA/EIA-568-B).
CONNECTION OF THE ETHERNET CABLE
Pin number Cable colour
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 8
6.6.3 Connection of the power supply
line, 24Vac/24Vdc (version of the
product cabled)
Perform the connections following the instructions
reported in the table .
CONNECTION OF THE POWER SUPPLY LINE (24VAC/24VDC)
Colour Function Cable section
Black 1 ~/+ 1.5mm² (16AWG)
Black 2 ~/- 1.5mm² (16AWG)
Tab. 9
6.6.4 Connection of the power supply
line, PoE+ (version of the product
cabled)
The product can be directly connected to an
Ethernet switch equipped with a PoE+ (End-Span
configuration) port or a classic Ethernet switch using
a PoE Injector (Mid-Span configuration).