Operation, Installation and Maintenance Manual for 6414/11-Series
ID-No.:
240912 / 6414603300
Publication Code: 2015-04-30:BA00.lll.en.00 Page - 15 - of 17
9.
Operations
9.1
Trouble shooting
Cause
Measure
The lamp was incorrectly inserted.
Insert the lamp correctly.
The lamp is defective.
Replace the lamp.
The ballast is defective.
Replace the ballast.
The power switch is defective.
Replace the switch.
The lamp reached its end of service life.
Replace the lamp.
If the error cannot be eliminated using the mentioned procedures:
•
Contact the local representative of R. STAHL Schaltgeräte GmbH.
For fast processing, have the following information ready:
•
Type and serial number
•
Purchase information
•
Error description
•
Intended use (in particular input / output wiring)
10.
Maintenance and repair
WARNING
Unauthorized work being performed on the device!
Risk of injuries and material damage!
Work performed on the device must only be carried out by appropriately authorized and trained
personnel.
Risk of electric shock or malfunctioning of the device due to unauthorized work!
Non-compliance can result in severe injuries and material damage.
Work performed on the device must only be carried out by appropriately authorized and qualified
electricians.
10.1
Maintenance
Observe the relevant national regulations in the country of use.
•
Consult the relevant national regulations to determine the type and extent of inspections.
•
Adapt inspection intervals to the operating conditions.
