Operation, Installation and Maintenance Manual for 6414/11-Series
ID-No.:
240912 / 6414603300
Publication Code: 2015-04-30:BA00.lll.en.00 Page - 12 - of 17
Note:
a)
Version without switch: Disconnect the luminaire from the power supply and secure it against being switched on again.
b)
Version with switch: The luminaire is positively disconnected from the power supply by actuating the central lock.
c)
In opened condition and with luminaire cover swiveled down, a restart lock-out device prevents the central lock from being
actuated.
d)
Please do not use force!
e)
Only when the luminaire cover is closed, the central lock can be engaged.
f)
While trying to open or close, keep the Allen key pressed to the lock and then turn.
Opening and closing the reflector plate
1
Open the reflector plate by two(2 No’s) quarter turn screws.
2
Swivel down the reflector plate as shown in the diagram below.
3
When closing, flip up the reflector plate, snap it into place and fix it with by two(2 No’s) quarter turn screws.
quarter turn screws
to Lock the reflector Plate – 2 No.’s
7.3.2
Electrical Connections:
Observe the maximum clamping possibility of the connecting terminals (see chapter "Technical data").
For optional screw-type terminals, two conductors per clamping unit can be clamped (incoming and outgoing wiring).
Note:
Clamping must be carried out precisely!
Do not clamp any part of the conductor insulation!
Do not interchange the conductors!
Observe the technical regulations when connecting the conductor!
Clamp the conductor firmly.
Optional screw-type terminals: Firmly tighten screws (tightening torque 2 Nm, for unused clamping units 0.7 Nm)!
The terminal cover of optional screw-type terminals does not have to be removed to clamp the conductor!
