SSR RAZKULL 125, Руководство пользователя

Страница: 26 / 38

Adjustment and Lubrication of the Drive Chain
Check the tension of the drive chain. Apply chain lubricant if the chain is dry.
1.) Using your finger move the chain up and down, a moving range of 10-20mm is allowed.
2.) Check the chain function by turning the rear wheel. Apply chain lubricant if it is not rotating
freely until it no longer binds or is dry.
3.) Check the chain wear, if the chain or sprockets are found to have serious wear, it should be
replaced as a full set immediately. DO NOT use a new chain and old sprockets together which are
seriously worn, it will accelerate the wear of the chain. Loosen the rear wheel axle and adjust the
chain when it is needed.
Make sure the chain adjuster on the left and right (1) are adjusted evenly (2). Adjust until the
chain has the proper tension and then tighten the axle nut of the rear wheel axle. You must also
adjust the rear brake when making a drive chain adjustment to allow of the best rear brake per-
formance.
Drive Chain Lubrication
Lubricate the drive chain with a motorcycle specific drive chain lubricant. If it is necessary to
clean and then lubricate the drive chain then follow the steps below:
1.) Remove the countershaft sprocket cover, chain guard and remove the clip from the removable
chain link. Remove the drive chain.
2.) Clean the chain using a motorcycle chain cleaner to remove all of the soil and dirt, then dry it.
3.) Reinstall the chain after you have lubricated the chain, and assemble the removable chain link
again (making sure the clip is facing the direction of travel - see picture to the right).
4.) Adjust the chain’s tension and rear brake, reinstall the countershaft sprocket cover and the
chain guard.
Note: Ensure the chain link is installed in the correct position.
Drive Chain Link Clip
Chain Tension Diagram
10~20 mm
1 2