SSR RAZKULL 125, Руководство пользователя

Страница: 21 / 38

Maintenance and Service
Check and change the engine oil, clean the oil-filter mesh screen
Check the engine oil level before driving every day.
The engine oil level gauge (1) is located on the rear of the right crankcase cover, which is
used to measure the engine oil level. The level must be within the upper (2) and lower (3) oil
level marks on the dipstick.
1.) Place the motorcycle on a rear stand (sitting vertically), remove the engine oil dipstick
and clean it. Insert the engine oil dipstick into the crankcase and take out to check the re-
sult.
2.) Fill with engine oil until it reaches the upper dipstick mark. DO NOT overfill it.
3.) Reinstall the engine oil level dipstick, checking whether its leaking.
Note: When the engine is running, insufficient engine oil would damage the engine; it will
increase oil consumption and cause the engine to overheat causing engine seizure.
Changing the engine oil, clean the oil-filter mesh screen, drain the engine oil when the en-
gine is still warm.
1.) Remove the engine oil dipstick.
2.) Place an empty container under the engine, remove the oil drain bolt (4) which is under
the engine, take out the oil-filter mesh and spring.
3.) Make sure the ignition is off and kick the kickstarter lever several times to help drain the
oil.
4.) Clean the oil drain bolt, oil filter mesh and spring with contact cleaner.
5.) Reinstall the oil drain bolt, using a new crush gasket and making sure it is tight.
oil-filter mesh and spring with detergent. oil-filter mesh and spring and make sure
6.) Fill the engine with the recommended lubrication oil (1 liter), reinstall the engine oil
dipstick, and start the engine. Allow it to run for several minutes then turn it off, wait an-
other few minutes then remove the dipstick and check the engine oil level, add oil if neces-
sary.
Note:
If operating in a dusty area perform these services more often.
1
2
3
4