SSANGYONG OM600, Руководство по обслуживанию

Страница: 90 / 186

1B3-90 OM600 ENGINE MECHANICAL
15. Measure radial clearance of crankshaft bearing (G).
Clearance ‘G’ 0.027 - 0.051mm
Notice
If ‘G’ is out of standard, replace the bearing shells and
adjust the radial clearance of crankshaft bearing.
Example) Measured value ‘E’ = 57.700mm
Measured value ‘F’ = 57.659mm
Clearance ‘G’ = 0.041mm
16. Remove the crankshaft bearing cap.
17. Measure width of thrust bearing journal (H) and adjust with
proper thrust bearings (see table).
Notice
The same thickness of thrust washers should be installed
on both sides of the thrust bearing.
18. Coat the upper thrust bearing (4) with oil and insert into
the crankcase so that the oil grooves are facing the crank
webs (arrow).
19. Coat the lower thrust bearing (7) with oil and insert into the
crankshaft bearing cap so that the oil grooves are facing
the crank webs (arrow).
Notice
The retaining lugs should be positioned in the grooves
(arrow).