5. Align the new axle on the underside of the server. Replace the
stabilizer bar and replace the (4) screws. Tighten the screws to
secure the new axle into place.
6. Once all screws have been tightened, return the server to the
upright position. Slide the cover back on the server by aligning the
cover with the axle and pull towards the front of the server until
fully in place.
How to replace the all-angle axle:
1. Remove the cover from the server by opening the cover fully and
pushing back on the center base of the cover. Set aside.
2. Invert the server on a stable work area with the axle hanging off the
side of the work surface.
3. While supporting the axle from underneath, use a Phillips screwdriver
to remove the (4) screws that secure the axle.
4. Remove the stabilizer bar and set aside. Remove the axle from the
underside of the server.
10
11
