902-289 6’ Spiral Slide
Page
3
Rev. 07/22/03
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the parts and hardware with the packing list to be sure you have
received everything needed to assemble this product. CONTACT YOUR LOCAL
DISTRIBUTOR with notification of any missing or damaged parts. Contact MUST
be made within ten days of receipt of your order. Only hand-tighten nuts &
bolts on initial assembly. Final tightening should be done EVENLY after
final assembly when unit has been plumbed & leveled.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts.
ASSEMBLY AND INSTALLATION:
NOTE:
NOTE:
All threaded ends of bolts protruding beyond nuts must be cut off
and/or peened to eliminate sharp edges. No more than two threads
should extend beyond face of nut. All washers, “T” nuts, and other
fastener hardware used on round pipe or tubing must be hammered down to
conform to the curved underlying surface to eliminate catch points.
DO NOT tighten nuts more than hand-tight until entire assembly is
completed.
Slides should be installed in shaded areas or face NORTH to prevent
direct sun on slide’s chute.
NOTE:
Plumb and level entire unit. Tighten all nuts & Bolts until lock
washers are flat. Use short length of pipe on end of socket Key to add
leverage when tightening Socket Set Screws. Pour Concrete. Dome top
of cement for proper drainage. Wait 48 hours before removing braces,
applying resilient surfacing and using equipment.
NOTE:
Attach warning label and Manufacturer’s Identification label to a clean
surface. The labels should be attached in a location where they are
clearly visible and legible and away from normal hand and foot
placement areas. The labels must be replaced if they become illegible,
destroyed or removed. Contact your SportsPlay distributor for
replacements.
