17
STEP 12
Establish the Number of Products per Pod
Upon setup, the number of fitness products per pod must be entered into the
memory of each product. If this is not done properly, the inverter might get
overloaded and its fuse might break. The procedure to establish the number
of fitness products per pod is explained below.
First, some background information:
● A group of fitness products connected to one inverter is called a pod.
● The number of fitness products per pod determines the maximum power
output per unit.
●
One inverter can process up to 2000 watts of power. For a maximum of
Green System fitness products, please contact your local distributor.
● In general, the fewer fitness products per pod, the higher the power out
-
put limit per unit. However, since the maximum power output is capped at
250 watts per unit, fitness products in pods with eight or fewer units have a
maximum output of 250 watts per product.
●
For pods with eight or more units, the maximum output per product is
calculated by a formula: Divide 2000 (maximum watts produced by one
Green System) by the number of fitness products in the pod. For example,
for a ten-unit pod, calculate 2000/10=200. The maximum power output of
each unit in the 10-unit pod would be 200 watts. (This is the factory default
setting.) The power output limit of a product is calculated automatically once
the number of units in the pod has been established.
At setup, follow the procedure below to enter into each fitness product the
number of units in the pod.
1. Simultaneously press and hold WORKOUT LEVEL▲
+
WORKOUT
LEVEL ▼
+
CHANGE DISPLAY keys for two seconds. This will activate
the units-per-pod setting mode.
2. The message screen will show “PASSWORD-0000”. The passcode,
8250, must be entered before the number of units in the pod can be entered.
Follow instructions below to enter the passcode.
a. Use numeric keys 0 through 9 to enter the first digit of the four-digit
passcode 8250. After inputting the first digit, 8, press the ▼ key to confirm
your choice.
b. Then input the next number, 2, followed by the ▼ key. Proceed in this
fashion until all four digits of the passcode have been entered. If necessary,
press the ▲ key to return to a preceding entry. Then press the correct
numerical key. After inputting a number, always press the ▼ key to confirm
your choice.
c. After the four-digit passcode has been entered correctly, the product will
automatically enter the units-per-pod setting mode.
Содержание G862
Страница 42: ...41...