WWW.SPORTDOG.COM 11
MODE UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
# OF
DOGS
6
DOG #1
Audible Tone for 1 second,
then Low Continuous
Stimulation without Audible
Tone. Low Stimulation level
set by Dial.
DOG #2
Audible Tone for 1
second, then Low
Continuous Stimulation
without Audible Tone.
Low stimulation level set
by Dial.
DOG #3
Audible Tone for 1
second, then Low
Continuous Stimulation
without Audible Tone.
Low stimulation level set
by Dial.
3
7
DOG #1
Continuous Stimulation
without Audible Tone.
Stimulation level set by Dial.
DOG #2
Continuous Stimulation
without Audible Tone.
Stimulation level set by
Dial.
DOG #3
Continuous Stimulation
without Audible Tone.
Stimulation level set
by Dial.
3
8
DOG #1
Continuous Stimulation
without Audible Tone.
Stimulation level set by Dial.
When the button is released
there is a 1 second delay
followed by an Audible Tone
lasting for 1 second. If button
is pressed again before 1
second delay, the Audible
Tone is not delivered.
DOG #2
Continuous Stimulation
without Audible Tone.
Stimulation level set by
Dial. When the button
is released there is a 1
second delay followed by
an Audible Tone lasting
for 1 second. If button is
pressed again before 1
second delay, the Audible
Tone is not delivered.
DOG #3
Continuous Stimulation
without Audible Tone.
Stimulation level set by
Dial. When the button
is released there is a 1
second delay followed
by an Audible Tone
lasting for 1 second. If
button is pressed again
before 1 second delay,
the Audible Tone is not
delivered.
3
RESET THE COLLAR RECEIVER
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a new
Collar Receiver to work with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
fl ashing as normal. If this occurs, start over and repeat the process.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
fl ashes 5 times. You may need to hold both units 0.5-1m from each other before this occurs.
Once the Receiver Indicator Light has fl ashed 5 times, the Collar Receiver has been reset and
will begin fl ashing as normal. If the Receiver Indicator Light does not fl ash 5 times, start over
and repeat the process.
ST
E
P
::
06