5
First Steps
Selecting the best location for your pool.
1.
Locate a level site for the pool, as it should not be set up out of level by
more than one (1) inch. If such a location is not available, some ground work will be
necessary to achieve a level area for the pool.
2.
Never locate your pool under power lines nor is it recommended to locate in an easement.
3.
It is best to locate your pool as close as possible to a GFI (ground fault interruption) protected
electrical outlet with a weather cover.
4.
Inspect the selected site to remove all sharp objects, such as stones, sticks or other similar
objects. The cleared area should be 2ft larger all around the pool to allow for room to set up the
pool and for full leg extension. It is best to provide a 2” fine sand base for maximum protection
of your
TitanPool3
liner. If this is not available, a heavy gauge visquene separation sheet will
help to protect your liner.
5.
Your
Titan3 is approximately 49” tall when filled with water. Some localities do not require the
homeowner to obtain permits or to install a fence, if the pool wall height is more than 48” above
ground level. HOWEVER, it is the homeowner’s responsibility to meet all applicable safety,
health code and zoning regulations.
Now for the pool set-up:
1.
Unfold your pool liner on your selected, prepared site.
2.
Refer to the Box 4 instructions later in this manual for installing the fittings and hoses for
the skimmer and pump system. Be careful to locate the reinforced fitting holes closest
to the GFI protected power outlet.
3. Start by first inserting one (1) female end section of the top rail (C) through the slot in the
corner of the white top rail sleeve, followed by adding Middle Top Rail Sections (B), making
certain to insert the Section (B) into the end of the Section (C) and rotating this new section
until the snap pin in the male end of each part pops into the hole in the female companion
section. Continue with this process until the last piece (male end piece) is inserted to complete
the wall. Adjust the Top Rail pipe by rotating to align the holes in the Top Rail pipe with the
holes in the Top Rail Membrane. Continue installing each Top Rail Section until all four Top
Rails are completed.
Содержание TitanPool3
Страница 1: ...By Owner s Guide...
Страница 15: ...Titan3 Ladder Assembly Instructions...