SPINOGY Xcontrol-E, Руководство по эксплуатации

Страница: 6 / 31

6
01 GENERAL REMARKS
01 General remarks
01.1 Notice
This operating manual contains important information about handling the product. It has to be read carefully
before use. The Xcontrol-E may only be put into operation if the operating manual was understood completely.
If there are obscurities, SPINOGY must be contacted. Please follow the instructions of this operating manual. This
operating manual must be available for the user at any time and must be replaced in case of loss or impracticality
immediately. The obligation to retain applies as long as someone is in possession of the product.
The content of this operating manual is checked for conformity with the described incomplete machine, but
deviations and mistakes cannot be excluded. Technical and content-related changes, errors and misprints are
reserved.
This operating manual is subject to the copyright law and may not be reproduced, copied or changed in any form,
neither all nor part, without the permission of the author. In case of contravention, there is a risk of criminal
prosecution. All rights reserved.
01.2 Limitation of liability
SPINOGY doesn’t assume liability for personal injuries, material damages, damages caused to the device and
consequential damages caused by failure to follow this operating manual, improper use of the device, repairs or
any other actions done by non-qualified workers (See chapter 2.3 personnel requisition) damages on this unit
occur or occurred by using unauthorized non-approved spare parts. Non-compliance of maintenance intervals
and maintenance specification of the manufacturer does also lead to limitation of liability. (Please see chapter 7
– maintenance) In addition, it is strictly prohibited to make any unauthorized modifications or technical changes
on the device.
01.3 Product name
This operating manual is created for the following product:
Product name:
Xcontrol-E, Xcontrol-E DIY
Compatible with
spindle:
XP001, XP002, XP003, XP004, XP005, XP006, XP007, XP008, XP021, XP022,
XP023, XP024 (as well as all configurations of these spindles)
01.4 Labeling of Xcontrol-P
X X X X X X
The Xcontrol-E is labeled with a six-digit serial number. The serial
number is located on the upper-left side of the door, pursuant to the
following picture.
Using this serial number, all necessary information about the
Xcontrol-E can be obtained from SPINOGY at any time.